Page History

Answer:

An example is provided below for a dissolution test of a conventional-release formulation.

If the Q has been value was set as to 75% of dissolved active substancethe label claim dissolved within a specified time, the acceptance criteria would be interpreted as follows:

At acceptance level S₁: 6 dosage units are tested :and each individual dissolution result is compared to Q+5%.

At - Acceptance criterion at level S₁: each value of the 6 dosage units tested is not less than 80%has to be more than 80% of the label claim dissolved within the specified time (i.e. 75%+5%=80%). If the results fulfil this requirement, the medicinal product  complies with the test.

If the result does results do not conformcomply, a further 6 additional dosage units are tested:

- Acceptance criterion at At acceptance level S₂: the average value of the all 12 dosage units tested in levels S₁ and S₂ is has to be equal to or greater than 75% , and no dosage unit is less than 60%of the label claim dissolved within the specified time and none of the values can be less than 60% (Q-15%: 75%-15%=60%). If the results fulfil this requirement, the medicinal product complies with the test at level S₂.

If the result results still does do not conformcomply, a further 12 additional dosage units are tested:

- Acceptance criterion at At acceptance level S₃: the average value of the all 24 dosage units tested in levels S₁, S₂ and S₃ is has to be equal to or greater than 75% , not of the label claim dissolved within the specified time, no more than 2 dosage units are values can be less than 60%, and no dosage unit is value can be less than 50%. If the results fulfil this requirement, the medicinal product complies with the test at level S₃.

If the result results still does not conform the test would be considered as faileddo not comply, the medicinal product has failed the test and an out-of-specification investigation must be launched.

For more information, refer to Ph. Eur. general chapter 5.17.1.